How To Remove Residue From Hardwood Floors

Download Article

If yous are ripping up any type of floor covering, y'all might exist thrilled to notice beautiful hardwood underneath. Your excitement may then be macerated, however, by the fact that you are left with a sticky glue or adhesive roofing the wood. Because most adhesives offset out in liquid class, the best way to thoroughly remove them is by returning them to that state (much the same way yous would re-melt candle wax to remove it). At that place also are commercial products like strippers and adhesive removers available on the market place. Another option is to use dry ice.

1

Bring a pot of water to a eddy. Place a pot with 4-6 cups of water on the stove, and wait for it to boil. Yous could also use an electric kettle to bring your water to a boiling point.
2

Soak towels in the hot h2o. Use old towels that are already stained or muddied, just still make clean. Saturate them completely with hot h2o. Be conscientious non to scald your hands.^[1]

Advertisement
3

Place the moisture towels on the floor. This keeps the hot water contained and allows information technology to remainder over the surface of the adhesive, heating information technology up and loosening it.^[2]
4

Leave towels in place. Exit the towels in place for three-5 minutes. And so wipe the surface of the floors with the towels. The adhesive should be melted plenty to start coming off.^[3]
5

Scrape whatsoever stubborn adhesive off with a flooring scraper. Gently run the floor scraper over the surface of any remaining adhesive. Exist careful non to seriously scratch or damage your floor.^[4]

Advertisement

one

Locate a estrus gun. The purpose of using the heat gun is to reheat the adhesive for like shooting fish in a barrel removal. Plug in the heat gun and ensure information technology will reach your work area. You may demand to employ an extension cord.
two

Use estrus to the agglutinative. Direct the heat gun toward the adhesive. Identify the heat gun as close to the adhesive equally possible without touching it. Continue until you see the adhesive begin to give and cook.
3

Wipe the area with a dry towel. Use an old, but make clean, towel to begin to wipe away the melted adhesive. Y'all may want to re-heat the adhesive and wipe again.
iv

Use a scraper to lift any leftover residue. Carefully motion your floor scraper over the surface of any remaining adhesive. Move gently enough to avoid dissentious your floor.

Advertisement

ane

Purchase a commercial glue/adhesive remover. ^[5] These products are specially helpful for removing tough carpet adhesive (which have replaced tack strips in recent years). You lot can detect a product like this at any hardware shop.^[6]
two

Article of clothing gloves, protective eyewear, and a mask. Commercial adhesive removers are very potent. Information technology is of import for you lot to put on safety gloves to protect your hands from any chemicals. You lot should likewise wear protective eyewear and a mask.^[7]
3

Test the adhesive remover. Information technology's a good idea to exam the adhesive remover first to see if it works well. Choose a small area, similar a closet, to see if the adhesive remover works well or if it has a negative reaction, such equally staining your wood.
iv

Pour a small corporeality of adhesive remover onto a damp sponge. Begin with just a small-scale amount of agglutinative remover (this product is very powerful), post-obit the instructions listed on the parcel. Then, using your sponge, employ the adhesive remover to the adhesive on your floor.
v

Give it some time. Exit the adhesive remover on long plenty to loosen the adhesive (approximately v minutes, or according to the manufacturer's instructions).^[8]
6

Use a scraper to remove any residuum. Once more, work advisedly with the scraper, using soft motions and taking care not to gouge your hardwood floor.

Advertisement

i

Assemble supplies. You are going to need gloves, protective eyewear, a metal cookie sheet or tray, and a ½ lb (227-gram) block of dry water ice. Dry water ice can be purchased at many grocery stores, as well as some hardware stores.^[9]
2

Put on your gloves and protective eyewear. Equally with the commercial agglutinative remover, dry ice is quite powerful. It is necessary for y'all to protect your hands and eyes by wearing rubber gloves and protective eyewear whenever you handle dry water ice.^[10]
3

Place your ½ lb block of dry ice on a metal cookie sheet or tray. Using a gloved hand, center your ½ lb block of dry ice on a metallic cookie sheet. The cookie sheet should be large enough to cover the area where y'all'd similar to remove the agglutinative. If it is not, you can always echo this process.^[11]
4

Place the tray straight on top of the agglutinative and permit it to sit for 1 minute. The dry ice will harden then crack the adhesive. This is perchance the quickest and cleanest method of loosening and removing floor adhesive.^[12]
five

Remove the tray and use a scraper to lift off the croaky pieces of adhesive. As e'er, apply gentle pressure level and soft motions, as yous do not want to damage your flooring.^[thirteen]

Advertisement

Add New Question

Question

What should I practice if the agglutinative is all the same wet?

Ryaan Tuttle is a Home Improvement Specialist and the CEO of All-time Handyman Boston. With over xv years of experience, Ryaan specializes in domicile comeback and property maintenance past leveraging engineering science and adroitness. Ryaan holds his Construction Supervisor and Home Improvement Contractor Licenses. Unlike nearly handyman contractors, All-time Handyman Boston is licensed and insured. Boston Mag and LocalBest.com have named Best Handyman Boston the Best Handyman in Boston.

Home Comeback Specialist

Expert Respond
Question

After cleaning a laminate flooring with Goo Gone how do I clean off the oil information technology left behind?

Marking Spelman is a General Contractor based in Austin, Texas. With over 30 years of construction experience, Marker specializes in amalgam interiors, project management, and projection estimation. He has been a construction professional person since 1987.

Construction Professional

Good Answer
Question

Nosotros accept adhesive pads on our chairs to protect the wood floor. Somewhen the pads dislodge and the adhesive is rubbed into the wood floors equally the chairs are pushed in and out. How can I remove the adhesive from the floor?

Mark Spelman is a General Contractor based in Austin, Texas. With over xxx years of construction experience, Mark specializes in constructing interiors, project management, and project estimation. He has been a construction professional since 1987.

Structure Professional

Expert Reply

Ask a Question

200 characters left

Include your e-mail address to get a message when this question is answered.

Submit

Video

When using chemic removers, wear a mask and work in a well-ventilated area or use fans to eliminate fumes.
Never store dry ice in an airtight container, as information technology can cause the container to burst.
Dispose of dry water ice by allowing it to evaporate exterior, or identify it in an open up container safely away from children or pets.
E'er wear gloves and protective eyewear when working with dry water ice, as it will cause burning of the skin if handled. If you come in contact with dry out ice and are burned or receive frostbite, consult medical personnel immediately.

Advertizement

Things You lot'll Need

Make clean towels
Floor scraper
Rubber gloves
Sponge
Commercial agglutinative remover
Dry ice
Metallic cooking sheet
Protective eyewear
Mask
Estrus gun

Nigh This Article

Article Summary X

To remove adhesive from a hardwood floor, bring a pot of water to a boil. Soak some one-time towels in the water and then place them on the adhesive. After letting them sit for three to five minutes, wipe off every bit much adhesive as you can. Gently utilise a flooring scraper to remove the rest of information technology. If that doesn't work, you lot can pour a pocket-sized amount of adhesive remover onto a sponge and use it to the glue. Wait five minutes and then scrape information technology off with a floor scraper. For advice from our Contractor reviewer on using oestrus guns and dry water ice to remove adhesive, read more!

Did this summary assistance you?

Thanks to all authors for creating a page that has been read 428,314 times.

Did this commodity assistance you?